| |
| |
|
|
| |
Digital
Air Control |
|
| |
 |
The digital display will allow you to
adjust the mattress from 0 to 40 mm/Hg. This pressure
monitoring scale is used world wide within the medical
profession to measure the pressure against the human body.
It is widely accepted throughout the medical profession
that any prolonged pressure against the human body above
32 mm/Hg will reduce blood flow in the areas that exceed
32 mm/Hg. This highly advanced Intelligent-Air Sleep Technology
control system will constantly display the internal pressure
of the air chamber. The control system will not let you
over inflate the system and therefore has a maximum pressure
of 40. Once you have reached this point it will not allow
you to add any additional air pressure to the mattress.
Please note that if you fill the mattress to the maximum
level of 40 while you are off of the mattress and then
lie down on the mattress you will find that the pressure
displayed is now beyond the 40. It is also important to
know that as the air temperature changes the internal
pressure of the air chamber changes slightly as well. |
|
|
| |
When you first inflate a large amount of air
in the air chambers the air is warm from being compressed and
pushed through the pumping system. As it cools and reaches room
temperature the pressure will fall slightly and you may need
to adjust it once more before you reach your favorite setting.
You may also notice slight changes of the pressure displayed
on the remote control which are caused by changes in the room
temperature. In fact, you may notice that the display reads
slightly higher after a nights sleep. This is caused by your
body heat heating the air contained in the air chambers.To adjust
the mattress to your desired comfort level. First, while lying
on the mattress use the hand control to adjust the firmness
to your desired comfort level. Note: while the mattress is inflating
the numbers will bounce around due to the fact that the air
being transferred from the pump to the mattress has not been
equalized. Once you stop inflating the mattress the pressure
will equalize within a second and the proper pressure reading
will be displayed. The digital display will constantly read
and display the internal pressure of the air chambers. You will
notice that when you change positions, exit or enter the bed
that the numbers displayed will change. Once you have chosen
your desired comfort level you can save that setting to one
of the two memory settings. This is accomplished by pressing
and holding one of the memory buttons until it begins to flash.
Once the number begins to flash you can release the button because
it has now memorized that pressure setting. You can also repeat
this process with the remaining memory button. If you should
ever choose to change the memory settings you may do so by repeating
the above steps. |
|
| |
|
|
| |
|
|
| |
|
|
| |
|
|
|
|
